NETGEAR FSM7328SNA Administration Manual page 73

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Adding the Ports to the LAGs
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 0/2
(Netgear Switch) (Interface 0/2)#addport 1/1
(Netgear Switch) (Interface 0/2)#exit
(Netgear Switch) (Config)#interface 0/3
(Netgear Switch) (Interface 0/3)#addport 1/1
(Netgear Switch) (Interface 0/3)#exit
(Netgear Switch) (Config)#interface 0/8
(Netgear Switch) (Interface 0/8)#addport 1/2
(Netgear Switch) (Interface 0/8)#exit
(Netgear Switch) (Config)#interface 0/9
(Netgear Switch) (Interface 0/9)#addport 1/2
(Netgear Switch) (Interface 0/9)#exit
(Netgear Switch) (Config)#exit
Web Interface: Adding the Ports to the LAGs
To use the Web interface to configure the switch, proceed as follows:
1. Add ports to the lag_10.
a. From the main menu, select Switching > LAG >LAG Membership. A screen similar to the
following displays.
Figure 4-4
b. Select the Lag 1 in the LAG ID field.
c. Click the Unit 1. The Ports display.
d. Click on the gray box under port 2 and 3. Two flags appear in the box.
Link Aggregation
v1.0, October 2009
4-4