NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) (Config)#interface tunnel 0
(Netgear Switch) (Interface tunnel 0)#ipv6 enable
(Netgear Switch) (Interface tunnel 0)#ipv6 address 2000::2/64
(Netgear Switch) (Interface tunnel 0)#tunnel mode ipv6ip
(Netgear Switch) (Interface tunnel 0)#tunnel source 192.168.1.2
(Netgear Switch) (Interface tunnel 0)#tunnel destination 192.168.1.1
(Netgear Switch) (Interface tunnel 0)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show interface tunnel
TunnelId
Interface
--------
---------
0 tunnel
0
Web Interface: Creating a Tunnel
On GSM7328S_1
To use the Web interface to create a tunnel, proceed as follows:
1.
Enable IP routing on the switch.
a.
From the main menu, select Routing > IP >Basic>IP Configuration. A screen similar to the
following displays.
Figure 26-2
b. Next to the Routing Mode, select the Enable Radio button.
c.
Click Apply.
2.
Enable IPv6 forwarding and unicast routing on the switch.
Tunnel
TunnelMode
----------
6 in 4 Configured
v1.0, October 2009
SourceAddress
DestinationAddress
-------------
------------------
192.168.1.2
192.168.1.1
26-3