Write Data Buffer Function - Renesas H8S/2633 Series Hardware Manual

Hide thumbs Also See for H8S/2633 Series:

Table of Contents

Write Data Buffer Function

DMAC internal-to-external dual address transfers and single address transfers can be executed at

high speed using the write data buffer function, enabling system throughput to be improved.

When the WDBE bit of BCRL in the bus controller is set to 1, enabling the write data buffer

function, dual address transfer external write cycles or single address transfers and internal

accesses (on-chip memory or internal I/O registers) are executed in parallel. Internal accesses are

independent of the bus master, and DMAC dead cycles are regarded as internal accesses.

A low level can always be output from the TEND pin if the bus cycle in which a low level is to be

output is an external bus cycle. However, a low level is not output from the TEND pin if the bus

cycle in which a low level is to be output from the TEND pin is an internal bus cycle, and an

external write cycle is executed in parallel with this cycle.

Figure 8-33 shows an example of burst mode transfer from on-chip RAM to external memory

using the write data buffer function.

Internal address

Internal read signal

External address

Figure 8-33 Example of Dual Address Transfer Using Write Data Buffer Function

Figure 8-34 shows an example of single address transfer using the write data buffer function. In

this example, the CPU program area is in on-chip memory.