Renesas H8S/2633 Series Hardware Manual page 57

Item Specification
•
Data transfer
•
1
controller (DTC) *
•
•
•
16-bit timer-pulse
•
unit (TPU)
•
•
Programmable
•
pulse generator
(PPG) •
•
•
1
8-bit timer *
4 channels
•
•
•
Watchdog timer
•
2
2 channels *
•
14-bit PWM timer
1
(PWM) *
•
•
•
Serial
•
communication
interface (SCI)
•
5 channels
(SCI0 to SCI4)
•
1
IrDA-equipped SCI *
1 channel (SCI0)
•
•
•
•
Notes: *1 This function is not available in the H8S/2695.
*2 The watchdog timer in the H8S/2695 has one channel only.
Can be activated by internal interrupt or software
Multiple transfers or multiple types of transfer possible for one activation
source
Transfer possible in repeat mode, block transfer mode, etc.
Request can be sent to CPU for interrupt that activated DTC
6-channel 16-bit timer on-chip
Pulse I/O processing capability for up to 16 pins'
Automatic 2-phase encoder count capability
Maximum 16-bit pulse output possible with TPU as time base
Output trigger selectable in 4-bit groups
Non-overlap margin can be set
Direct output or inverse output setting possible
8-bit up counter (external event count possible)
Time constant register × 2
2 channel connection possible
Watchdog timer or interval timer selectable
Operation using sub-clock supported (WDT1 only)
Maximum of 4 outputs
Resolution: 1/16384
Maximum carrier frequency: 390.6 kHz (operating at 25 MHz),
437.6 kHz (operating at 28 MHz)
Asynchronous mode or synchronous mode selectable
Multiprocessor communication function
Smart card interface function
Supports IrDA standard version 1.0
TxD and RxD encoding/decoding in IrDA format
Start/stop synchronization mode or clock synchronization mode selectable
Multiprocessor communications function
Smart card interface function
3