A/D Control Register (Adcr) - Renesas H8S/2633 Series Hardware Manual

19.2.3

A/D Control Register (ADCR)

Bit : 7
TRGS1
Initial value : 0
R/W : R/W
ADCR is an 8-bit readable/writable register that enables or disables external triggering of A/D
conversion operations and sets the A/D conversion time.
ADCR is initialized to H'33 by a reset, and in standby mode or module stop mode.
Bits 7 and 6—Timer Trigger Select 1 and 0 (TRGS1, TRGS0): Select enabling or disabling of
the start of A/D conversion by a trigger signal. Only set bits TRGS1 and TRGS0 while conversion
is stopped (ADST = 0).
Bit 7 Bit 6
TRGS1 TRGS0
0 0
1
1 0
1
Note: * This function is not available in the H8S/2695.
Bits 5, 4, 1, and 0—Reserved: They are always read as 1 and cannot be modified.
Bits 3 and 2—Clock Select 1 and 0 (CKS1, CKS0): These bits select the A/D conversion time.
The conversion time should be changed only when ADST = 0.
Set bits CKS1 and CKS0 to give a conversion time of at least 10 µs when AV
least 16 µs when AV
CC
Bit 3 Bit 2
CKS1 CKS0
0 0
1
1 0
1
6 5
TRGS0 —
0 1
R/W —
Description
A/D conversion start by software is enabled
A/D conversion start by TPU conversion start trigger is enabled
A/D conversion start by 8-bit timer * conversion start trigger is enabled
A/D conversion start by external trigger pin (ADTRG) is enabled
< 4.5 V.
Description
Conversion time = 530 states (max.)
Conversion time = 266 states (max.)
Conversion time = 134 states (max.)
Conversion time = 68 states (max.)
4 3 2
— CKS1 CKS0
1 0 0
— R/W R/W
1 0
— —
1 1
— —
(Initial value)
≥ 4.5 V, and at
CC
(Initial value)
867