Table of Contents
Advertisement
IRQ
interrupt
Interrupt source
On-chip
clear signal
supporting
module
Note: * This function is not available in the H8S/2695.
Figure 5-9 Interrupt Control for DTC* and DMAC*
Operation (DMAC and DTC functions are not available in the H8S/2695)
5.6.3
The interrupt controller has three main functions in DTC and DMAC control.
(1) Selection of Interrupt Source: DMAC inputs activation factor directly to each channel. The
activation factors for each channel of DMAC are selected by DTF3 to DTF0 bits of DMACR. The
DTA bit of DMABCR can be used to select whether the selected activation factors are managed
by DMAC. By setting the DTA bit to 1, the interrupt factor which were the activation factor for
that DMAC do not act as the DTC activation factor or the CPU interrupt factor.
Interrupt factors other than the interrupts managed by the DMAC are selected as DTC activation
request or CPU interrupt request by the DTCERA to DTCERF of DTC and the DTCE bit of
DTCERI.
By specifying the DISEL bit of the DTC's MRB, it is possible to clear the DTCE bit to 0 after
DTC data transfer, and request a CPU interrupt.
Interrupt
request
Selection
circuit
Select
signal
Clear signal
DTCER
DTVECR
clear signal
Interrupt controller
DMAC *
Control logic
SWDTE
Determination of
priority
DTC activation
request vector
number
DTC *
Clear signal
CPU interrupt
request vector
number
CPU
I, I2 to I0
151
Advertisement
Table of Contents
