Break Control Register B (Bcrb); Module Stop Control Register C (Mstpcrc) - Renesas H8S/2633 Series Hardware Manual

6.2.4

Break Control Register B (BCRB)

BCRB is the channel B break control register. The bit configuration is the same as for BCRA.
6.2.5

Module Stop Control Register C (MSTPCRC)

7
Bit :
MSTPC7
Initial value : 1
R/W : R/W
MSTPCRC is an 8-bit readable/writable register that performs module stop mode control.
When the MSTPC4 bit is set to 1, PC break controller operation is stopped at the end of the bus
cycle, and module stop mode is entered. Register read/write accesses are not possible in module
stop mode. For details, see section 24.5, Module Stop Mode.
MSTPCRC is initialized to H'FF by a power on reset and in hardware standby mode. It is not
initialized by a manual reset and in software standby mode.
Bit 4—Module Stop (MSTPC4): Specifies the PC break controller module stop mode.
Bit 4
MSTPC4 Description
0 PC break controller module stop mode is cleared
1 PC break controller module stop mode is set
158
6 5
MSTPC6 MSTPC5 MSTPC4
1 1
R/W R/W
4 3
MSTPC3 MSTPC2
1 1
R/W R/W R/W
2 1 0
MSTPC1 MSTPC0
1 1
1
R/W R/W
(Initial value)