Renesas H8S/2633 Series Hardware Manual page 28

H8S/2633F-ZTAT
PV = 3.0 V to 5.5 V, V
CC
[When using A/D or D/A]
AV = 3.6 V to 5.5 V, Vref = 3.6 V to AV
CC
[When not using A/D or D/A]
AV = 3.3 V to 5.5 V, Vref = 3.3 V to AV
CC
Power 2 power supply configurations, PV
supply V (3 V power supply), PLLV
CC
pins
× 0.8 V to V
EXTAL V : V
IH CC
input level
V : –0.3 V to V
IL CC
(V = 3.0 V to 3.6 V)
CC
Interrupt External interrupts: NMLIRQ7 to IRQ0
sources Internal interrupts: 72 sources
32 kHz Yes (subactive mode, subsleep mode, and watch mode supported)
oscillator
Method of
fixing OSC
pin when
32 kHz
oscillator
not used
H8S/2633 Series
H8S/2633 H8S/2632
= PLLV = 3.0 V to 3.6 V
CC CC
CC
CC
(5 V power supply) and
CC
is 3 V power supply
CC
+ 0.3 V
CC
× 0.2 V
V power supply
CC
OSC1
Open
OSC2
H8S/2633R Series
H8S/2631 H8S/2633RF-ZTAT
Vref = 4.5 V to AV
• PV (5 V power supply) single power
CC
supply configuration
• Do not connect the VCL pin to the
power supply. Instead, connect it to a
ground via a 0.1 µF power supply
stabilizer capacitor (which should be
mounted close to the pin).
• Do not connect the V
to the VCL pin.
• Note that the VCL pin is located in the
same position as the V
older H8S/2633 Series and
H8S/2633F.
External
capacitor
0.1 µF
• There is no PLLV
× 0.8 V to PV
V : PV
IH CC
V : –0.3 V to PV
IL
(PV = 4.5 V to 5.5 V)
CC
OSC1
OSC2
H8S/2695
CC
power supply
CC
pin on the
CC
VCL (pin 11: FP128B)
(pin 7: TFP120)
V (pin 9: FP128B)
SS
(pin 5: TFP120)
power supply pin.
CC
+ 0.3 V
CC
× 0.2 V
CC
External interrupts:
NMLIRQ7 to IRQ0
Internal interrupts:
49 sources
No (subactive
mode, subsleep
mode, and watch
mode not
supported)
No 32 kHz
oscillator.
GND
The HD6432695 is
the HD6432633
Open
Series. The pins
corresponding to
OSC1 and OSC2 in
the HD64F2633 are
NC pins in the
HD6432695.