Renesas H8S/2633 Series Hardware Manual page 362

DREQ Level Activation Timing (Normal Mode): Set the DTA bit for the channel for which the
DREQ pin is selected to 1.
Figure 8-25 shows an example of DREQ level activated normal mode transfer.
ø
DREQ
Address bus
DMA control
Idle
Channel
Request
Minimum of 2 cycles
[1]
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising
[1]
edge of ø, and the request is held.
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] The DMA cycle is started.
[4] [7] Acceptance is resumed after the write cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of ø, and the request is held.)
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Figure 8-25 Example of DREQ Level Activated Normal Mode Transfer
DREQ pin sampling is performed every cycle, with the rising edge of the next ø cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared. After the end of the write cycle, acceptance resumes, DREQ pin low level
sampling is performed again, and this operation is repeated until the transfer ends.
308
Bus DMA
release read
Transfer
source destination
Read Write
Request clear period
[2] [3]
DMA Bus DMA
write release read
Transfer Transfer
source
Idle Read
Request clear period
Request
Minimum of 2 cycles
[4] [5] [6]
Acceptance resumes
DMA Bus
write release
Transfer
destination
Write Idle
[7]
Acceptance resumes