Configuring An Additional Metric For A Rip Interface - HP 3600 v2 series Configuration Manual

[SwitchB-acl-basic-2000] rule deny source 10.2.1.1 0.0.0.255
[SwitchB-acl-basic-2000] rule permit
[SwitchB-acl-basic-2000] quit
[SwitchB] rip 200
[SwitchB-rip-200] filter-policy 2000 export rip 100
# Display the routing table of Switch C.
[SwitchC] display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
11.1.1.0/24
12.3.1.0/24
12.3.1.2/32
16.4.1.0/24
16.4.1.1/32
127.0.0.0/8
127.0.0.1/32

Configuring an additional metric for a RIP interface

Network requirements
In the following figure, RIP is enabled on all the interfaces of Switch A, Switch B, Switch C, Switch D, and
Switch E. The switches are interconnected through RIPv2.
Switch A has two links to Switch D. The link from Switch B to Switch D is more stable than that from Switch
C to Switch D. Configure an additional metric for RIP routes received through VLAN-interface 200 on
Switch A so that Switch A prefers the 1.1.5.0/24 network learned from Switch B.
Figure 12 Network diagram
Configuration procedure
Configure IP addresses for the interfaces. (Details not shown)
1.
Configure RIP basic functions.
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] rip 1
[SwitchA-rip-1] network 1.0.0.0
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
Routes : 7
Proto Pre Cost
RIP 100 1
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
41
NextHop Interface
12.3.1.1 Vlan200
12.3.1.2 Vlan200
127.0.0.1 InLoop0
16.4.1.1 Vlan400
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0