Memory Auto-Establish Disable - 3Com 5500G-EI Command Reference Manual

232 C 6: U R
HAPTER SING
memory auto-establish
disable
P C
OUTING ROTOCOL OMMANDS
Example
Display the current memory setting and state information.
<SW5500>display memory limit
Current memory limit configuration information:
system memory safety: 2 (MBytes)
system memory limit: 1 (MBytes)
auto-establish enabled
Free Memory: 67397036 (Bytes)
The state information about connection:
The times of disconnect: 0
The times of reconnect: 0
The current state: Normal
The displayed information is defined in
Table 42 Output Description of the
Item
system memory safety
system memory limit
auto-establish enabled
Free Memory: 17781708
(Byte)
The times of disconnect: 0
The times of reconnect: 0
The current state: Normal
Syntax

memory auto-establish disable

View
System View
Parameter
None
Description
Use the
memory auto-establish disable
protocol connection that is forcibly disconnected to recover automatically when
the idle memory of the Ethernet switch reaches this value. Thus, connections of all
the routing protocols will not recover when the idle memory of the Ethernet
switch recovers to a safety value. In this case, you need to restart the routing
protocol to recover the connections.
By default, when the idle memory of the Ethernet switch recovers to a safety
value, connections of all the routing protocols will always recover (when the idle
Table 42.
display memory limit
Description
The safety value of the Switch memory
The lower limit of the Switch memory
The system allows recovering the connection automatically. (If
the automatic recover is disabled, auto-establish
disable will be displayed.)
The size of the current idle memory is 17781708 bytes, that is,
17,782Mbytes.
The times of the connection disconnecting of the Switch is 0.
The times of the connection reestablishment of the Switch is 0.
The current state is normal. If entering the emergent state, the
display will read Exigence.
command to disable the routing
Command