Memory Auto-Establish Disable - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
The information displayed by this command includes Ethernet switch memory limit,
size of free memory, times of disconnection, times of reconnection, and the current
state.
The following table describes the fields of the command:
Table 7-2 Description on the fields of the display memory limit command
system memory safety
system memory limit
auto-establish enabled
Free Memory
The times of disconnect: 0
The times of reconnect: 0
The current state: Normal

7.1.3 memory auto-establish disable

Syntax
memory auto-establish disable
View
System view
Parameter
None
Description
Use the memory auto-establish disable command to disable the automatic
restoration of routing protocol connection (even if the free memory recovers to a
safety value).
By default, when the free memory of the switch recovers to a safety value,
connections of all the routing protocols will always recover (when the free memory of
the switch decreases to a lower limit, the connection will be disconnected forcibly).
Field
Safety value of the switch memory.
Lower limit of the switch memory.
Automatic connection restoration is enabled (If
automatic
"auto-establish disabled" is displayed).
Size of the current free memory in bytes
The times of the disconnection of the routing protocol is
0.
The times of reconnection of the routing protocol is 0.
The current state is normal (If the current state is
emergent, "Exigence" is displayed).
Chapter 7 Route Capacity Configuration Commands
Description
connection
7-3
restoration is disabled,