User-Interface - 3Com 5500G-EI Command Reference Manual

44 C 1: U S
HAPTER SING YSTEM

user-interface

A C
CCESS OMMANDS
Parameter
Enter the host name of the remote Switch. It is configured using the
hostname:
command.
ip host
Enter the IP address or the host name of the remote Switch. If you
ip_address:
enter the host name, the Switch must be set to static resolution.
Designates the management port on the remote Switch, in the
service_port:
range 0 to 65535. Optional.
Description
Use the command to log in to another Ethernet switch from the current
telnet
switch via Telnet for remote management. To terminate the Telnet logon, press
<Ctrl+K> .
If you do not specify a
used.
Related command:
display tcp status
Example
To log in to the Ethernet switch Switch32 at IP address 10.1.1.1 from the current
Switch (Switch01), enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface vty 0 4
[SW5500-ui-vty0-4]authentication-mode none
<Switch01>telnet 10.1.1.1
Trying 10.1.1.1.....
Press CTRL+K to abort
Connected to 10.1.1.1...
*********************************************************
* All rights reserved (1997-2005)
* Without the owner's prior written consent,
*no decompiling or reverse-engineering shall be allowed.*
*********************************************************
<Switch32>
Syntax
type
user-interface [
View
System view
Parameter
Enter the user interface type, which can be aux or vty.
type:
Specifies the number of the first user interface to be configured..
first_number:
Specifies the number of the last user interface to be configured.
last_number:
, the default Telnet port number of 23 is
service_port
.
first_number
] [
*
*
last_number
]