Ip Address Configuration Commands; Display Ip Host; Display Ip Interface - 3Com 5500G-EI Command Reference Manual

104 C 5: U
HAPTER SING
IP Address
Configuration
Commands

display ip host

display ip interface

N P C
ETWORK ROTOCOL OMMANDS
This section describes the commands you can use to configure and manage IP
Addressing on your Switch 5500G-EI.
Syntax
display ip host
View
All Views
Parameter
None
Description
Use the
display ip host
corresponding IP addresses.
Example
To display all host names and their corresponding IP addresses, type the following:
<SW5500>display ip host
The information displays in the following format:
Host Age
My 0
Aa 0
Syntax
display ip interface
View
All views
Parameter
Enter the identifier of the vlan interface.
vlan_id
Description
Use the
display ip interface vlan-interface
on the specified interface.
Example
To display information for VLAN-interface 1, enter the following:
<SW5500>display ip interface vlan-interface 1
The information displays in the following format:
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
command to display all host names and their
Flags Address
static 1.1.1.1
static 2.2.2.4
interface-type interface-number
command to view information