Resilient Arp Configuration Commands; Debugging Resilient-Arp - 3Com 5500G-EI Command Reference Manual

112 C 5: U
HAPTER SING
Resilient ARP
Configuration
Commands

debugging resilient-arp

N P C
ETWORK ROTOCOL OMMANDS
Description
Use the
reset arp
from the ARP mapping table. You can remove entries of a specified type, or from a
specified port.
Use the
reset arp
this entry.
Use the
reset arp dynamic
Use the
reset arp static
Use the
display arp interface
port.
Related command:
Example
To clear static ARP entries, enter the following:
<SW5500>reset arp static
This section describes the commands you can use to configure and manage the
Resilient ARP operations
Syntax
debugging resilient-arp { packet | state | error | all }
undo debugging resilient-arp { packet | state | error | all }
View
User view
Parameters
Enter to enable debugging resilient ARP packets.
packet
Enter to enable debugging resilient ARP state machine.
state
Enter to enable debugging resilient ARP errors (including packet errors).
error
Enter to enable all resilient ARP debugging.
all
Description
Use the
debugging resilient-arp
Use the
undo debugging resilient-arp
debugging.
By default, all resilient ARP debugging is disabled.
command to remove information that is no longer required
command to clear all ARP entries. You are asked to confirm
command to clear all dynamic ARP entries.
command to clear all static ARP entries.
command to clear all entries for the specified
,
arp static display arp
command to enable resilient ARP debugging.
.
command to disable resilient ARP