Stop-Accounting-Buffer Enable; Timer - 3Com 5500G-EI Command Reference Manual

392 C 11: U AAA RADIUS C
HAPTER SING AND OMMANDS
stop-accounting-buffer Syntax
enable

stop-accounting-buffer enable

undo stop-accounting-buffer enable
View
RADIUS Scheme View
Parameter
None
Description
Use the command to configure to save the
stop-accounting-buffer enable
stopping accounting requests without response in the Switch buffer. Use the
undo
command to cancel the function of saving the
stop-accounting-buffer enable
stopping accounting requests without response in the Switch buffer.
By default, enable to save the stopping accounting requests in the buffer.
Because the stopping accounting request concerns the account balance and will
affect the amount of charge, which is very important for both the user and ISP,
NAS shall make its best effort to send the message to the RADIUS accounting
server. Accordingly, if the message from the Switch to the RADIUS accounting
server has not been responded to, the Switch shall save it in the local buffer and
retransmit it until the server responds or discard the messages after transmitting
for a specified number of times.
Related commands: , ,
reset stop-accounting-buffer radius scheme display
.
stop-accounting-buffer
Example
To indicate that, for the server "3Com" in the RADIUS scheme, the Switch will
save the stopping accounting request packets in the buffer, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]stop-accounting-buffer enable

timer

Syntax
timer second s
undo timer
View
RADIUS Scheme View
Parameter
RADIUS server response timeout timer, ranging from 1 to 10 and
seconds
:
measured in seconds. By default, the value is 3.