If-Match { Acl | Ip-Prefix - 3Com 5500G-EI Command Reference Manual

if-match { acl | ip-prefix }

It may be necessary that only the routing information that meets special conditions
can be received. Then, the filter-policy command can be used to set the filtering
conditions for the received routing information. Only the routing information
passing the filtration can be received.
Related command:
filter-policy export
Example
Define the filtering rule for receiving routing information of RIP. Only the routing
information filtered through the address prefix list p1 can be received by RIP.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]filter-policy ip-prefix p1 import
Syntax
acl
if-match { acl _
undo if-match [ acl | ip-prefix ]
View
Route Policy view
Parameter
Enter the number of the access control list used for filtration
acl_number
Enter the prefix address list used for filtration
ip_prefix_name
Description
Use the
if-match { acl | ip-prefix }
range to match the Route-policy.
Use the
undo if-match { acl | ip-prefix }
the match rule.
Filtration is performed by quoting an ACL or a prefix address list.
Related command:
if-match interface
, ,
cost if-match tag route-policy
cost, apply local-preference, apply origin and apply tag
Example
Define one sub-statement. When the sub-statement is used for filtering
if-match
route information, the route information filtered by the route destination address
through address prefix list p1 can pass the
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]route-policy permit node 1
% New sequence of this list
[SW5500-route-policy]if-match ip-prefix p1
IP Routing Policy Configuration Commands
.
number
| ip-prefix
command to configure the IP address
,
if-match ip next-hop
,
apply cost
if-match
ip prefix name
_ _ }
command to cancel the setting of
,
,
apply ip next-hop, apply
.
sub-statement.
225
if-match