User Privilege Level; Using Port - 3Com 5500G-EI Command Reference Manual

user privilege level

Description
Using
user-interface
multiple user interface views to configure the corresponding user interfaces.
Example
To configure the user interfaces with index numbers 0 to 9, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface 0 9
[SW5500-ui0-9]
This example command selects two AUX (Console) port user interfaces and two
VTY user interfaces (VTY 0, VTY 1). You can now assign access levels to these
interfaces using the user privilege level command.
Syntax
user privilege level
undo user privilege level
View
User interface view
Parameter
Enter the level of command that a user can access, in the range 0 to 3.
level:
Description
Use the
user privilege level level
that a user can access from the specified user interface. The user can use all the
available commands at this command level. Use the
command to restore the default command level. By default, a user can access all
commands at Level 3 after logging in through the AUX user interface, and all
commands at Level 0 after logging in through a VTY user interface.
Example
To configure a user to access command level 0 after logging in from the VTY 0
user interface, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user privilege level 0
When the user Telnets from the VTY 0 user interface to the switch, the terminal
displays commands at level 0, as shown below:
<SW5500>?
User view commands:
language-mode
ping
quit
super
telnet
tracert
command, you can enter single user interface view or
level
command to configure the command level
Specify the language environment
Ping function
Exit from current command view
Set the current user priority level
Establish one TELNET connection
Trace route function
Logging in Commands
undo user privilege level
45