Basic System Configuration And Management Commands; Clock Datetime - 3Com 5500G-EI Command Reference Manual

442 C 12: U
HAPTER SING
Basic System
Configuration and
Management
Commands

clock datetime

S M C
YSTEM ANAGEMENT OMMANDS
Two formats can be used to set the waiting delay of timing reboot switch, namely
the format of "hour: minute" and the format of "absolute minutes". But the total
minutes should be no more than 30×24×60 minutes, or 30 days.
After this command is configured, the system will prompt you to input
confirmation information. Only after the "Y" or the "y" is entered can the
configuration be valid. If there is related configuration before, it will be covered
directly.
After the
schedule reboot at
adjusted by the
become invalid.
For the related command, see
reboot, display schedule reboot
Example
Configure the switch to be restarted after 88 minutes (the current time is 21:32).
<SW5500>schedule reboot delay 88
Reboot scheduled for 23:00:00 UTC 2002/11/1 (in 1 hours and 28
minutes)
Proceed with reboot? [Y/N]:y
This section describes the basic system configuration and system management
commands available on your Switch 5500G-EI.
Syntax
clock datetime
View
User view
Parameters
enter the current time in
time :
23. and can be in the range 0 to 59.
MM SS
date : enter the current year in
in the range 2000 to 2099.
1 to 31.
Description
Use the
clock datetime
default is 23:55:52, 2000/4/1.
Related command:
Example
To set the system time and date to 09:30:00, 2004/1/1, enter the following:
command is configured, and the system time is
command, the original
clock
reboot, schedule reboot at, undo schedule
time date
HH:MM:SS
MM/DD/YYYY
can be in the range 1 to 12.
MM
command to set the current system time and date. The
display clock
schedule reboot at
format . can be in the range 0 to
HH
or format .
YYYY/MM/DD
can be in the range
DD
parameter will
can be
YYYY