Igmp Group-Policy - 3Com 5500G-EI Command Reference Manual

igmp group-policy

undo igmp group-limit
View
VLAN Interface View
Parameter
Number of multicast groups, in the range of 0 to 1024.
number :
Description
Use the
igmp group-limit
Use the
undo igmp group-limit
By default, you can add up to 1024 IGMP groups on an interface.
If the existing IGMP groups exceed the quantity limit you configured using this
command, the system will not delete the existing entries.
The new configuration overwrites the old one if you run the command for a
second time.
Example
Limit the maximum IGMP groups at Vlan-interface10 to 100.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]interface Vlan-interface 10
[SW5500-Vlan-interface10] igmp group-limit 100
Syntax
igmp group-policy acl-number
interface_ num interface_name
|
num interface_name
|
undo igmp group-policy [ port {
interface_name } [ to {
interface_name } ] ]
View
VLAN Interface View
Parameter
Number of the basic IP ACL number, defining a multicast group
acl-number :
range. The value ranges from 2000 to 2999.
IGMP version 1.
1:
IGMP version 2. If IGMP version is not specified, version 2 will be used as
2:
default.
Packets received and sent by the port(s) and applied to the conditions set by
port:
the ACL will be filtered. And the port(s) must belong to the VLAN interface being
configured by this command.
IGMP Configuration Commands
command to limit multicast groups on an interface.
command to restore the default setting.
[ 1 | 2 | port {
} [ to {
} ] ]
interface_type interface_ num
interface_type interface_ num
interface_type
interface_type interface_
|
253
|