Route Capacity
Configuration
Commands
display memory
display memory limit
This section describes the commands you can use to configure route capacity on
the Switch.
Syntax
display memory [ unit
Mode
Any View
Parameter
Enter the unit ID.
unit-id
Description
Use the display memory command to view the memory setting.
Example
To display the current memory setting, enter the following:
<SW5500> display memory
Unit 1
System Available Memory(bytes): 92412672
System Used Memory(bytes): 25011700
Used Rate: 27%
The displayed information is defined in
Table 41 Output Description of the
Item
Unit 1
System Total Memory(bytes)
Total Used Memory(bytes)
Used Rate
Syntax
display memory limit
Mode
All Views
Parameter
None
Description
Use the
display memory limit
state information related to the Ethernet switch capacity, including available
memory and state information about connections, such as times for disconnecting
connections, times for reestablishing connections, and the current state of the
system.
Route Capacity Configuration Commands
unit-id
]
Table
41.
display memory
Description
Display the memory information of unit 1.
The total number of the Switch memory in bytes.
The total number of the used Switch memory in bytes.
The used rate of the Switch memory.
command to display the memory setting and
Command
231