Peer; Preference - 3Com 5500G-EI Command Reference Manual

214 C 6: U R
HAPTER SING

peer

preference

P C
OUTING ROTOCOL OMMANDS
Syntax
ip_address
peer
ip
undo peer _
View
OSPF View
Parameter
Enter the IP address of the neighboring router.
ip_address
dr_priority_number
priority value of the network neighbor. The range is from 0 to 255. The default
value is 1.
Description
Using the
peer
connected to a network of NBMA type. Using the
cancel the configured neighboring point.
Example
To configure the IP address of the neighboring router to 10.1.1.1, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]peer 10.1.1.1
Syntax
preference [ ase ]
undo preference [ ase ]
View
OSPF View
Parameter
Enter the OSPF protocol route preference, ranging from 1 to 255.
value
Enter to indicate the preference of an imported external route of the AS.
ase
Description
Using the
preference
preference.
Using the
undo preference
OSPF protocol route. By default, the preference of an OSPF protocol internal route
is 10 and the preference of an external route is 150.
dr
[ dr-priority
address
Enter the priority value that represents the corresponding
command, you can configure the neighboring point if a router is
value
command, you can configure the OSPF protocol route
command, you can restore the default value of the
priority number
_ _ ]
undo peer
command, you can