Display Startup; Reset Saved-Configuration - 3Com 5500G-EI Command Reference Manual

414 C 12: U
HAPTER SING

display startup

reset
saved-configuration
S M C
YSTEM ANAGEMENT OMMANDS
configurations of the protocol views are displayed when executing this command
in protocol sub-views.
For the related command, see
current-configuration, display saved-configuration
Example
Display the configuration parameters for the current view of the switch system.
[SW5500]display this
Syntax
display startup [ unit
View
All views
Parameter
: Specify the Unit ID of switch.
unit-id
unit
Description
Use the
display startup
configuration filenames used for the current and the next start-ups.
This command is used to display the following information:
Filename of the system software configured by the user
■
Filename of the system software actually used for this startup
■
Filename of the system software configured for the next startup
■
Configuration filename used for the current startup
■
Configuration filename configured for the next startup.
■
For the related command, see
Example
Display the filenames related to the current and the next enabling.
<SW5500>display startup
UNIT1:
Startup saved-configuration file:
Next startup saved-configuration file:
Bootrom-access enable state:
Syntax

reset saved-configuration

View
User view
save, reset, saved-configuration, display
unit-id
]
command, to display the related system software and
startup saved-configuration
.
.
flash:/sw5500cfg.cfg
flash:/sw5500cfg.cfg
enabled