Access Management Configuration Commands; Am Enable; Am Ip-Pool - 3Com 5500G-EI Command Reference Manual

Version 3.1.x
Hide thumbs Also See for 5500G-EI:
Table of Contents

Advertisement

124
C
5: U
HAPTER
SING
Access Management
Configuration
Commands

am enable

am ip-pool

N
P
C
ETWORK
ROTOCOL
OMMANDS
The information displays in the following format:
The DHCP server group of this interface is 0
The information shown above indicates that vlan-interface 2 is configured with a
DHCP Server group whose ID is 0.
This section describes the commands you can use to configure and manage the
Access Management Configuration operations on your Switch 5500G-EI.
Syntax
am enable
undo am enable
View
System View
Parameter
None
Description
Use the
am enable
Use the
undo am enable
By default, the Access management function is disabled.
When using the access management function, It is recommended that you cancel
the static ARP configuration to ensure that the binding of the IP address and
Ethernet switch takes effect. If you have configured the static ARP for an IP
address in the current port IP address pool from another port, the system will
prompt you to cancel the static ARP setting.
Example
To enable the access management function, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]am enable
Syntax
am ip-pool
address-list
undo am ip-pool { all |
View
Ethernet Port View
Parameters
Enter to configure to operate on all the IP addresses (or IP address pools).
all
command to enable the access management function.
command to disable the function.
address-list
}

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superstack 4 5500g-ei series

Table of Contents