Dhcp-Server Ip - 3Com 5500G-EI Command Reference Manual

Use the
selected DHCP Server group. By default, DHCP Server requests are not forwarded.
You can only add the primary VLAN interface to a DHCP Server group. The primary
VLAN interface is the first interface that you configure.
This command has more parameters when entered in system view. Refer to

dhcp-server ip

Related commands:
dhcp-server interface vlan-interface, debugging dhcp-relay
Example
To add VLAN-Interface 1 to DHCP Server group1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]dhcp-server 1
dhcp-server ip Syntax
dhcp-server
undo dhcp-server
View
System View
Parameters
groupNo
ipaddress1
ipaddress2
Description
Use the
Server used by the DHCP Server group.
Use the
Servers in DHCP Server group.
This command has fewer parameters when entered in VLAN Interface View. Refer
to
dhcp-server
Related commands:
Example
To configure the primary and secondary IP addresses of DHCP Server group 1 as
1.1.1.1 and 2.2.2.2 respectively, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]dhcp-server 1 ip 1.1.1.1 2.2.2.2
command to remove the VLAN interface from the
undo dhcp-server
below for details.
dhcp-server ip
groupNo ip ipaddress1
groupNo
Enter the DHCP server group number, in the range 0 to 19.
Enter the IP address of the primary Server in the group.
Enter the IP address of the secondary Server in the group. Optional.
command to configure the IP address of the DHCP
dhcp-server ip
undo dhcp-server ip
command for details.
dhcp-server
DHCP Relay Configuration Commands
,
display dhcp-server
[ ipaddress2
command to delete the IP addresses of all DHCP
,
debugging dhcp-relay
121
,
display
.
]
.