Ntp-Service Authentication-Keyid; Ntp-Service Broadcast-Client - 3Com 5500G-EI Command Reference Manual

ntp-service
authentication-keyid
ntp-service
broadcast-client
Parameters
None
Description
Use the
ntp-service authentication enable
NTP-service authentication function, if no IP address is specified, the switch
automatically selects 224.0.1.1 as the multicast IP address. Use the
ntp-service authentication enable
address is specified, the switch will disable the configuration of the multicast IP
address 224.0.1.1.
By default, the authentication is disabled.
Example
Enable NTP authentication function.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]ntp-service authentication enable
Syntax

ntp-service authentication-keyid

value
undo ntp-service authentication-keyid
View
System view
Parameter
: Specify the key number and range from 1 to 4294967295.
number
: Specify the value of the key with 1 to 32 ASCII characters.
value
Description
Use the
ntp-service authentication-keyid
authentication key. Use the
command to cancel the NTP authentication key.
By default, there is no authentication key.
Only MD5 authentication is supported for the NTP authentication key settings.
Example
Set MD5 authentication key 10 as BetterKey.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
SW5500]ntp-service authentication-keyid 10 authentication-mode md5
BetterKey
Syntax

ntp-service broadcast-client

NTP Configuration Commands
command to enable the
command to disable this function, if no IP
number authentication-mode md5
number
command to set NTP
undo ntp-service authentication-keyid
505
undo