Display Interface - 3Com 5500G-EI Command Reference Manual

Description
Use the
the
By default, an Ethernet port does not have a description.
Example
Set the description of port Ethernet1/0/1 to be lanswitch-interface.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]description lanswitch-interface

display interface

Syntax
display interface [
interface_type interface_number
View
All views
Parameter
interface_type:
GigabitEthernet
interface_number
unit-number/0/port-number.
The unit number is a number in the range 1 to 8.
The port number is a number in the range 1 to 28 or 1 to 52 depending on the
number of ports you have on your unit.
You can use the
interface_type
example Ethernet1/0/1.
Description
Use the
the selected interface. Along with others, this interface could be a specific port's
interface (for example, Ethernet1/0/1) or a specific VLAN interface (for example,
vlan-interface 1).
Example
To display configuration information on Ethernet port 1/0/1, enter the following:
<SW5500>display interface Ethernet 1/0/1
The information displays in the following format:
Ethernet1/0/1 current state : UP
command to enter a description of an Ethernet port. Use
description
command to cancel the description.
undo description
interface_type
Enter the interface type. This can be either
,
NULL, Vlan-interface
: Enter the interface number in the format
interface_name
and the
interface_number
display interface
Ethernet Port Configuration Commands
|
]
.
at this command. This consists of the
combined as a single parameter. For
command to view the configuration information on
51
, ,
Aux Ethernet