Reset; Rip - 3Com 5500G-EI Command Reference Manual

168 C 6: U R
HAPTER SING

reset

P C
OUTING ROTOCOL OMMANDS
Parameter
Enter the preference level, in the range 1 to 255. By default, the value is
value
100.
Description
Use the
preference
Use the
undo preference
The default value of each routing protocol is determined by the specific routing
policy. This "preference" determines the optimal route in the IP routing table. You
can use this command to modify the RIP preference.
Example
To specify an RIP preference of 20, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]preference 20
Syntax
reset
View
RIP view
Parameter
None
Description
Use the command to reset the system configuration parameters of RIP.
reset
When you need to re-configure parameters of RIP, this command can be used to
restore to the default setting.
Example
Reset the RIP system.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]reset

rip

Syntax
rip
undo rip
View
System View
command to configure the route preference of RIP.
command to restore the default preference.