Display Ospf Vlink - 3Com 5500G-EI Command Reference Manual

200 C 6: U R
HAPTER SING

display ospf vlink

P C
OUTING ROTOCOL OMMANDS
Table 37 Output Description of the
Field
Destination
Cost
Type
NextHop
AdvRouter
Area
Intra Area
Inter Area
ASE
NSSA
Syntax
display ospf [
View
All Views
Parameter
: Enter the process ID of OSPF, ranging from 1 to 65535. The
process-id
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the
display ospf vlink
virtual links.
Example
To view OSPF virtual links information, enter the following:
<SW5500>display ospf vlink
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Virtual links
Virtual-link Neighbor-id
Cost: 0 State: Full Type: Virtual
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 38 Output Description of the
Field
Virtual-link
Neighbor-id
State
Interface
display ospf routing
Description
Destination of network segment
Cost of route
Type of route
Next hop of route
Router ID of the router advertising the route
Area ID
Number of intra-area routes
Number of inter-area routes
Number of external routes
Number of NSSA routes
process-id
] vlink
command to view the information about OSPF
-> 2.2.2.2, State: Full
display ospf vlink
Description
Router ID of virtual-link neighbor router
State
IP address of the interface on the virtual link
Command
Command