Arp Configuration Commands; Arp Check Enable; Arp Static - 3Com 5500G-EI Command Reference Manual

ARP Configuration
Commands

arp check enable

arp static

Example
To enter a host name of Lanswitch1 for the IP address 202.38.0.8, enter the
following .
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]ip host Lanswitch1 202.38.0.8
This section describes the commands you can use to configure and manage the
Address Resolution Protocol (ARP) operations on your Switch 5500G-EI.
Syntax
arp check enable
undo arp check enable
View
System View
Parameter
None
Description
Use the
arp check enable
the device does not learn the ARP entry where the MAC address is a multicast
MAC address. Use the
of ARP entry so the device learns the ARP entry where the MAC address is a
multicast MAC address.
By default, the checking of ARP entry is enabled and the device does not learn the
ARP entry where the MAC address is a multicast MAC address.
Example
Configure that the device learns the ARP entry where the MAC address is
multicast MAC address.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]undo arp check enable
Syntax
ip_address mac_address
arp static
interface_number
}]
ip_address
undo arp static
View
System View
Parameters
Enter the IP address of the ARP mapping entry.
ip_address
command to enable the checking of an ARP entry so
undo arp check enable
vlan_id
[

ARP Configuration Commands

command to disable the checking
interface_type
{
107
|