Dot1X - 3Com 5500G-EI Command Reference Manual

344 C 11: U
HAPTER SING

dot1x

AAA RADIUS C
AND OMMANDS
Configuration: Transmit Period 30 s,
Total maximum 802.1x user resource number is 1024
Total current used 802.1x resource number is 0
GigabitEthernet1/0/1 is link-up
802.1X protocol is disabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
The port is a(n) authenticator
Authenticate Mode is auto
Port Control Type is Mac-based
Max on-line user number is 256
... (Omitted)
Syntax
dot1x [ interface
undo dot1x [ interface
View
Ethernet Port View
Parameter
interface-list
interface
interface-list
interface-num
interface-type interface-num
specifies the port type,
interface-name
ranges, read the Parameter of the Port Configuration section.
Description
Use the command to enable 802.1x on the specified port or globally, (that is
dot1x
on the current device). Use the
the specified port or globally.
By default, 802.1x is disabled on all the ports and globally on the device.
This command is used to enable the 802.1x on the current device or on the
specified port. When it is used in System View, if the parameter
specified, 802.1x will be globally enabled. If the parameter
specified, 802.1x will be enabled on the specified port. When this command is
used in Ethernet Port View, the parameter interface-list cannot be entered and
802.1x can only be enabled on the current port.
The configuration command can be used to configure the global or port 802.1x
performance parameters before or after 802.1x is enabled. Before 802.1x is
Quiet Period 60 s,
Supp Timeout 30 s,
The maximum retransmitting time 2
interface-list
interface-list
Ethernet port list including several Ethernet ports.
:
= { interface-num
specifies a single Ethernet port in the format
interface-name
|
interface-num
specifies the port name. For the respective meanings and value
undo dot1x
Handshake Period 15 s
Quiet Period Timer is disabled
Server Timeout 100 s
]
]
[ to interface-num
interface-num
, where
}
specifies the port number and
command to disable the 802.1x on
ports-list
] } & < 1-10 >.
= {
interface-type
is not
ports-list
is