Dhcp Client Configuration Commands; Debugging Dhcp Client; Debugging Dhcp Xrn Xha - 3Com 5500G-EI Command Reference Manual

116 C 5: U
HAPTER SING
DHCP Client
Configuration
Commands

debugging dhcp client

debugging dhcp xrn xha

N P C
ETWORK ROTOCOL OMMANDS
Example
To configure VLAN interface 1 to obtain IP address using BOOTP, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ip address bootp-alloc
This section describes the commands you can use to configure and manage the
Dynamic Host Configuration Protocol (DHCP) Client operations on your Switch
5500G-EI.
Syntax
debugging dhcp client { all | error | event | packet }
undo debugging dhcp client { all | error | event | packet }
View
User view
Parameters
Enter to enable all DHCP client debugging.
all
Enter to enable DHCP client error (including packet unrecognizable )
error
debugging.
Enter to enable DHCP client event (including address allocation and data
event
update) debugging.
Enter to enable DHCP client packet debugging.
packet
Description
Use the
debugging dhcp client
Use the u
ndo debugging dhcp client
debugging.
By default, all DHCP client debugging is disabled.
Example
To enable DHCP client event debugging, enter the following:
<SW5500>debugging dhcp client event
Syntax
debugging dhcp xrn xha
undo debugging dhcp xrn xha
View
User view
command to enable DHCP client debugging.
command to disable DHCP client