Vlink-Peer - 3Com 5500G-EI Command Reference Manual

View
OSPF Area view
Parameter
no-summary
Description
Using the
Using the
areas are set as Stub areas.
If the router is an ABR, it will send a default route to the connected stub area.
Using the
Related commands:
Example
To set the type of OSPF area 1 to Stub, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf]area 1
[SW5500-ospf-1-area-0.0.0.1]stub

vlink-peer

Syntax
vlink-peer
trans-delay
]*
undo vlink-peer
View
OSPF Area view
Parameter
router_id
seconds
hello
range 1 to 8192 seconds. This must equal the hello seconds value of the router
virtually linked to the interface. The default value is 10 seconds.
retransmit
an interface, in the range 1 to 8192 seconds. The default value is 5 seconds.
trans-delay
interface, in the range 1 to 8192 seconds. The default value is 1 second.
dead seconds
value must equal the dead time of the virtually linked router, and must be at least
four times that of the hello interval. The default value is 40 seconds.
Enter to prevent the transmission of Summary LSAs to the Stub area.
command, you can configure the type of an OSPF area as "stub".
stub
command, you can cancel the setting. By default, no OSPF
undo stub
command, you can configure the default route cost.
default-cost
default-cost.
router_id
[ hello
seconds | dead seconds
router id
-
Enter the Router ID of a virtual link neighbor.
Enter the interval for the transmission of hello packets, in the
Enter the interval for the retransmission of LSA packets on
seconds
Enter the delay interval for transmitting LSA packets on an
seconds
Enter the dead time interval, in the range 1 to 8192 seconds. This
OSPF Configuration Commands
seconds
| retransmit
| simple password
219
seconds
|
| md5 keyid key