Loopback-Detection Per-Vlan Enable; Multicast-Suppression - 3Com 5500G-EI Command Reference Manual

60 C 2: U P
HAPTER SING ORT
loopback-detection
per-vlan enable

multicast-suppression

C
OMMANDS
By default, the interval is 30 seconds.
Description
Use the
loopback-detection interval-time
detection interval for the external loopback condition of each port. Use the
loopback-detection interval-time
Related commands:
Example
To configure the detection interval for the external loopback condition of each
port to 10 seconds, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]loopback-detection interval-time 10
Syntax

loopback-detection per-vlan enable

undo loopback-detection per-vlan enable
View
Ethernet Port View
Parameter
None
Description
Use the
loopback-detection per-vlan enable
system to perform loopback detection on all VLANs on Trunk and Hybrid ports.
Use the
undo loopback-detection per-vlan enable
system to only perform loopback detection on the default VLANs on the port.
By default, the system performs loopback detection to the default VLAN on Trunk
and Hybrid ports.
Example
Configure the detection interval for the external loopback condition of each port
to 10 seconds.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]loopback-detection per-vlan enable
Syntax
multicast-suppression {
undo multicast-suppression
command to restore the default interval.
display loopback-detection
ratio
| pps
command to configure the
command to configure the
command to configure the
pps
}
undo