Display Ntp-Service Sessions; Display Ntp-Service Status - 3Com 5500G-EI Command Reference Manual

502 C 12: U
HAPTER SING
display ntp-service
sessions
display ntp-service
status
S M C
YSTEM ANAGEMENT OMMANDS
Syntax
display ntp-service sessions [ verbose ]
View
All views.
Parameter
: display detailed information about the sessions.
verbose
Description
Use the

display ntp-service sessions

the sessions maintained by NTP service provided by the local equipment.
By default, the status of all the sessions maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the
will only display brief information about all the sessions it maintains.
With the
verbose
information about all the sessions it maintains.
Example
<SW5500>display ntp-service sessions
The information displays in the following format:
source
****************************************************************************
[12345]212.125.95.4
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Syntax

display ntp-service status

Views
All views.
Parameter
None
Description
Use the command
status.
Example
<SW5500>display ntp-service status
The information displays in the following format:
clock status: unsynchronized
clock stratum: 16
reference clock ID: none
nominal frequency: 100.0000 Hz
parameter configured, the Switch will display detailed
refid st
131.188.3.221 2
display ntp-service status
command to display the status of all
parameter, the Switch
verbose
now poll reach delay offset
18 64 377 339.8
to display the NTP service
disp
10.8 0.9