Snmp-Agent Usm-User - 3Com 5500G-EI Command Reference Manual

snmp-agent usm-user

Example
Configure the IP address of the VLAN interface 1 as the source address for
transmitting the Trap packets.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap source vlan-interface 1
Syntax
snmp-agent usm-user { v1 | v2c }
undo snmp-agent usm-user { v1 | v2c }
snmp-agent usm-user v3
authpassstring
md5 | sha }
acl-list
[ acl ]
undo snmp-agent usm-user v3
engine-id }
View
System view
Parameter
Enter the user name, up to 32 characters in length.
username
:
Enter the group name corresponding to that user, up to 32 characters
groupname :
in length.
Specifies the use of V1 safe mode.
v1:
Specifies the use of V2c safe mode.
v2c:
Specifies the use of V3 safe mode.
v3:
authentication-mode:
Specifies that the MD5 algorithm is used in authentication. MD5
md5:
authentication uses a128-bit password. The computation speed of MD5 is faster
than that of SHA
Specifies that the SHA algorithm is used in authentication. SHA
sha:
authentication uses a 160-bit password. The computation speed of SHA is slower
than that of MD5, but SHA offers higher security.
Enter the authentication password, up to 64 characters in
authpassstring
:
length.
Specifies the use of authentication and encryption.
privacy-mode:
Specifies that the DES encryption algorithm is used. Must be entered if
des 56:
you enter the
privacy-mode
SNMP Configuration Commands
username groupname
username groupname
username groupname
[ privacy-mode { des56
username groupname
Specifies the use of authentication.
parameter.
acl-list
[ acl
[ authentication-mode {
privpassstring
{ local | engineid
489
]
}]]