Pim Sm; Pim Timer Hello - 3Com 5500G-EI Command Reference Manual

[SW5500-acl-basic-2000]rule permit source 10.10.1.2 0
[SW5500-acl-basic-2000]rule deny source 10.10.1.1 0

pim sm

Syntax
pim sm
undo pim sm
View
Interface View
Parameter
None
Description
Use the
Use the
By default, PIM-SM is disabled.
Once PIM-SM is enabled on an interface, PIM-DM cannot be enabled on the same
interface and vice versa.
Example
Enable PIM-SM on VLAN-interface10.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500]interface Vlan-interface-10
[SW5500-vlan-interface10]pim sm

pim timer hello

Syntax
pim timer hello
undo pim timer hello
View
Interface View
Parameter
seconds
By default, the interval value is 30 seconds.
Description
Use the
messages.
Use the
to enable the PIM-SM protocol on an interface.
pim sm
to disable the PIM-SM protocol.
undo pim sm
seconds
Interval of sending Hello messages in second ranging from 1 to 18000.
:
to configure the interval of sending PIM router Hello
pim timer hello
undo pim timer hello
PIM Configuration Commands
to restore the default interval value.
275