Count; Destination Ip - 3Com 5500G-EI Command Reference Manual

454 C 12: U S M C
HAPTER SING YSTEM ANAGEMENT OMMANDS
View
System View
Parameter
Specify the name of the administrator creating an HWPing
administrator-name:
test group.
Test operation tag.
operation-tag:
Description
Use the command to create an HWPing test group. Executing this
hwping
command allows the systemto access the HWPing test group view.
Example
Create an HWPing test group, where the administrator name is 'administrator'
and the test operation tag is 'icmp'.
[SW5500]hwping administrator icmp

count

Syntax
count times
undo count
View
HWPing Test Group View
Parameter
Number of test packets to be transmitted, in the range 1 to 15. Defaults to
times:
1.
Description
Use the count command to configure the number of packets to be sent for each
test.
Use the undo count command to restore the deault.
A test timer will start when the system send the first test packet. In the event that
the times argument is set greater than one, the system continues to send the
second one upon receipt of the reply of the first one. If receiving no reply upon
expiry of the timer, the system sends the second and all the remaining packets
likewise.
Example
Send ten packets for each test.
[SW5500-administrator-icmp]count 10

destination ip

Syntax
destination-ip ip-address
undo destination-ip