Display Link-Aggregation Interface - 3Com 5500G-EI Command Reference Manual

72 C 2: U P
HAPTER SING ORT
display
link-aggregation
interface
C
OMMANDS
Description
Use the
display link-aggregation verbose
information of a link aggregation, including aggregation ID, the type of
aggregation, load-sharing type, detailed local information (member ports, port
status, port priority, LACP state flag and operation key), and detailed remote
information (indexes of remote ports, port priority, LACP state flag, operation key
and system ID.)
Note that unlike a dynamic aggregation, a manual aggregation has no protocol to
get the remote peer information of the partner. Therefore, every item for the
remote peer is 0. This does not indicate the actual state of the remote peer.
Example
To display detailed information of aggregation group 1, enter the following:
<SW5500>display link-aggregation verbose 1
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Aggregation ID: 1, AggregationType: Manual,
Aggregation Description:
System ID: 0x8000, 0e0-fcff-ff04
Port Status: S -- Selected,
Local:
Port
--------------------------------------------------------------------
GigabitEthernet1/0/3
Remote:
Actor
--------------------------------------------------------------------
GigabitEthernet1/0/3
Syntax

display link-aggregation interface {

| interface _ name
interface name
_ } ]
View
Any view
Parameter
interface_type interface_ num
interface {
interface_type interface_ num
can specify multiple sequential ports with the to parameter, instead of specifying
only one port.
Specifies port name, in the format of
interface_name:
interface_type interface_num.
Specifies port type and
interface_type:
For more information, see the parameter item for the
T -- Standby
Status
S 32768
Partner Priority Flag Oper-Key SystemID
32768 0x3d3 0 0x8000,00e0-fcff-ff01
} [ to { interface _
interface_name
|
interface_num
command to view detailed
Loadsharing Type: NonS
Priority Flag Oper-Key
0x3d
interface _ type interface
type interface-num
interface_name
|
Specifies ports. You
} ]:
interface_name =
port number.
interface
_ number
|
} [ to {
command.