Ethernet Port Link Aggregation Commands; Debugging Link-Aggregation Error - 3Com 5500G-EI Command Reference Manual

68 C 2: U
HAPTER SING
Ethernet Port Link
Aggregation
Commands
debugging
link-aggregation error
P C
ORT OMMANDS
Parameter
: Specifies the bandwidth ratio of unicast traffic allowed on an Ethernet
ratio
port. The ratio value ranges from 1 to 100. The incremental step is 1. By default,
the ratio is 100 meaning all unicast traffic is accepted. The smaller the ratio is, the
less bandwidth is allocated to unicast traffic and therefore less broadcast traffic is
accepted on the Ethernet port.
: Specifies the maximum number of unicast packets per second accepted
pps
pps
on an Ethernet port. Ranges from 1 to 148810 pps.
Description
Use
unicast-suppression
accepted on a port. Once the multicast traffic exceeds the value set by the user,
the excess unicast traffic will be discarded. This feature can be used to ensure
network service and prevent unicast storms.
Example
Enable a limit of 20% of the available bandwidth on a port to be allocated to
unicast traffic. Unicast traffic exceeding 20% of the ports bandwidth will be
discarded.
[SW5500-GigabitEthernet1/0/1]unicast-suppression 20
Specify the maximum packets per second of the unicast traffic on an
Ethernet1/0/1 as 1000 Mpps.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface ethernet 1/0/1
[SW5500-Ethernet1/0/1]unicast-suppression pps 1000
[SW5500-Ethernet1/0/1]
This section describes the commands you can use to configure Ethernet Port LInk
Aggregation on the Switch.
Syntax

debugging link-aggregation error

undo debugging link-aggregation error
View
User View
Parameter
None
to configure the amount of unicast traffic that will be