Rip Authentication-Mode - 3Com 5500G-EI Command Reference Manual

rip authentication-mode

Parameter
None
Description
Use the command to enable RIP and enter the RIP command view. From here,
rip
you can configure RIP using the other commands described in this section.
Use the command to disable RIP. By default, RIP is disabled.
undo rip
Enabling RIP does not affect interface configurations.
Example
To enable RIP, and enter RIP view, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]
Syntax
rip authentication-mode { simple
key-string key-id
nonstandard
undo rip authentication-mode
View
Interface View
Parameters
Enter to specify simple text authentication mode.
simple
Enter the simple text authentication key.
password
Enter to specify MD5 cipher text authentication mode.
md5
Enter to specify the MD5 cipher text authentication packet to use the
usual
general packet format (RFC1723 standard format).
Enter the MD5 cipher text authentication key. If it is entered in plain
key-string
text, the MD5 key is a character string not exceeding 16 characters. This key is
displayed in a cipher text form in a length of 24 characters when
current-configuration
text form with 24 characters long is also supported.
Enter to set the MD5 cipher text authentication packet to use a
nonstandard:
nonstandard packet format (as described in RFC2082).
Enter an MD5 cipher text authentication identifier, ranging from 1 to 255.
key-id
Description
Use the
rip authentication-mode
authentication mode and its parameters for the Switch 5500G-EI.
password
}}
command is executed. Inputting the MD5 key in cipher
command to configure the RIP-2
RIP Configuration Commands
key-string
| md5 { usual
display
169
|