Logon User's Acl Control Command; Acl - 3Com 5500G-EI Command Reference Manual

Logon user's ACL
Control Command
ip-precedence {
is in the range 0 to 7. from-cos sets the IP precedence value consistent with the
802.1p value.
pre-value
cos {
range 0 to 7. from-ipprec sets the 802.1p value consistent with the IP precedence
value.
local-precedence
Description
Use the
traffic-priority
that matches the ACL.
Use the
undo traffic-priority
You cannot remove traffic priority marking from the specific QoS profile which has
been applied to the port.
Example
To add to the student profile this preference replacing action: Sets local preference
0 to the inbound packets matching the ACL 2000, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]qos-profile student
[SW5500-qos-profilestudent]traffic-priority inbound ip-group 2000
local-precedence 0
This section describes how to use the Logon user's ACL control commands on your
Switch 5500G-EI.

acl

Syntax
acl-number
acl
undo acl { inbound | outbound }
View
VTY User Interface View
Parameter
The number identifier of basic and advanced number-based ACLs,
acl-number :
ranging from 2000 to 3999.
Performs ACL control to the users who access the local Switch using
inbound:
TELNET.
Performs ACL control to the users who access other Switches from the
outbound:
local Switch using TELNET.
pre-value
| from-cos }:
Sets the 802.1p value, pre-value is in the
| from-ipprec }:
Sets local preference value, in the range 0 to 7.
pre-value
:
command to enable traffic priority marking for traffic
command to remove traffic priority marking.
{ inbound | outbound }

Logon user's ACL Control Command

Set IP precedence value, pre-value
311