Reset Dot1X Statistics - 3Com 5500G-EI Command Reference Manual

reset dot1x statistics

quiet-period-value
:
from 10 to 120 in units of second and defaults to 60.
Specify the timeout timer of an Authentication Server. If an
server-timeout:
Authentication Server has not responded before the specified period expires, the
Authenticator will resend the authentication request.
server-timeout-value
Authentication Server is. The value ranges from 100 to 300 seconds and defaults
to 100 seconds.
Specify the authentication timeout timer of a Supplicant. After
supp-timeout:
the Authenticator sends Request/Challenge request packet which requests the
MD5 encrypted text, the supp-timeout timer of the Authenticator begins to run. If
the Supplicant does not respond back successfully within the time range set by
this timer, the Authenticator will resend the above packet.
supp-timeout-value :
timeout timer of a Supplicant is. The value ranges from 10 to 120 seconds and
defaults to 30 seconds.
Specify the transmission timeout timer. After the Authenticator sends
tx-period:
the Request/Identity request packet which requests the user name or user name
and password together, timer of the Authenticator begins to run. If the Supplicant
does not respond back with authentication reply packet successfully, then the
Authenticator will resend the authentication request packet.
Specify how long the duration of the transmission timeout
tx-period-value
:
timer is. The value ranges from 10 to 120 seconds and defaults to 30 seconds.
Description
Use the
dot1x timer
command to restore the default values.
dot1x timer
802.1x has many timers that control the rational and orderly interacting of the
Supplicant, the Authenticator and the Authentication Server. This command can
set some of the timers (while other timers cannot be set) to adapt the interaction
process. Changing the timers could be necessary in some special cases, but
generally the user should keep the default values.
Related command:
display dot1x
Example
To set the Authentication Server timeout timer to 150s, enter the following:
<SW5500> system-view
System View: return to User View with Ctrl+Z.
[SW5500]dot1x timer server-timeout 150
Syntax
reset dot1x statistics [ interface
Specify how long the quiet period is. The value ranges
Specify how long the duration of a timeout timer of an
:
Specify how long the duration of an authentication
command to configure the 802.1x timers. Use the
.
interface-list
802.1x Configuration Commands
]
353
undo