Undo Snmp-Agent; Rmon Configuration Commands - 3Com 5500G-EI Command Reference Manual

490 C 12: U
HAPTER SING

undo snmp-agent

RMON Configuration
Commands
S M C
YSTEM ANAGEMENT OMMANDS
privpassstring
from 1 to 64 bytes.
acl-list
acl :
Description
Use the
snmp-agent usm-user
you use the V3 parameter, a new user to an SNMP group.
Use the
undo snmp-agent usm-user
group.
SNMP engineID (for authentication) is required when configuring remote users.
This command will not be effective if engineID is not configured.
For V1 and V2C, this command will add a new community name. For V3, it will
add a new user for an SNMP group. See Related Commands below.
Related commands:
Example
To add a user named
MD5, and set the authentication password to
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent usm-user v3 JohnQ guest authentication-mode md5
pass
Syntax
undo snmp-agent
View
System view
Parameter
None
Description
Use the
undo snmp-agent
the server.
Any
snmp-agent
Example
Disable the running SNMP agents of all SNMP versions.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]undo snmp-agent
This section describes the Remote Monitoring (RMON) configuration commands
available on your Switch 5500G-EI.
Enter the encryption password with a character string, ranging
:
Enter the access control list for this user, based on USM name.
command to add a new community name or, if
command to delete a user from an SNMP
display snmp-agent
to the SNMP group
JohnQ
command to disable all versions of SNMP running on
command will enable SNMP Agent.
,
snmp-agent local engineid
, then configure the use of
guest
, enter the following:
pass