3Com 5500G-EI Command Reference Manual page 321

Parameter
interface_list
interface
Ethernet ports. Expressed as
interface_num
interface_name
|
For details about
the command in this manual.
port
Indicates the preceding parameter can be input up to 10 times.
&<1-10>
:
Description
Use the
reset stp
Spanning Tree Protocol (RSTP).
This command can be used to clear the statistics information about a specified
port. If no port is specified, the statistics information of all the ports of the device
will be cleared.
Related command:
Example
To clear the statistics information about GigabitEthernet1/0/1 through
GigabitEthernet1/0/3, enter the following:
<SW5500>reset stp interface GigabitEthernet1/0/1 to
GigabitEthernet1/0/3
stp Syntax
stp { enable | disable }
undo stp
View
Ethernet Port View
Parameter
Enables RSTP on a device or a port.
enable:
Disables RSTP on a device or a port.
disable:
Description
Use the
stp enable
Use the
stp disable
Use the
undo stp
By default, RSTP is enabled on the Switch and all ports.
If the parameters of RSTP have not been set for the device or the ports before
RSTP is enabled on the device, they will take the default values. Before or after
RSTP is enabled, you can use the configuration command to set RSTP parameters
Specifies the Ethernet port list, including multiple
:
interface _list = { {
| interface_name } [ to {
.
} ] }&<1-10>
,
interface_type interface_num
command to reset the statistics information about Rapid
.
display stp
command to enable RSTP on a device or port.
command to disable RSTP on a device or port.
command to disable RSTP on a device.
RSTP Configuration Commands
interface_type
interface_type interface_num
and
interface_name
325
, refer to