Igmp Configuration Commands; Debugging Igmp; Display Igmp Group - 3Com 5500G-EI Command Reference Manual

250 C 7: U
HAPTER SING
IGMP Configuration
Commands

debugging igmp

display igmp group

M P C
ULTICAST ROTOCOL OMMANDS
Example
Clear the route entry with address of 225.5.4.3 from the core multicast routing
table.
<SW5500>reset multicast routing-table 225.5.4.3
Clear statistic information of the forward entry with address of 225.5.4.3 from the
MFC forwarding table.
<SW5500>reset multicast forwarding-table statistics 225.5.4.3
This section describes how to use the IGMP Configuration commands on your
Switch 5500G-EI.
Syntax
debugging igmp { all | event | host | packet | timer }
undo debugging igmp { all | event | host | packet | timer }
View
User View
Parameter
Enables all the debugging information for IGMP functions.
all:
Enables debugging information for IGMP events.
event:
Enables debugging information for IGMP hosts
host:
Enables debugging information for IGMP packets.
packet:
Enables debugging information for IGMP timers.
timer:
Description
Use the
debugging igmp
Use the
undo debugging igmp
By default, IGMP debugging functions are disabled.
Example
Enable all IGMP debugging functions
<SW5500>debugging igmp all
Syntax
display igmp group [
interface-number
View
Any View
command to enable IGMP debugging functions.
command to disable the debugging functions.
group-address
| interface
]
interface-type