Tracert - 3Com 5500G-EI Command Reference Manual

host will be treated as IP address first. If it is not an IP address, perform domain
■
name resolution,
the default padding operation starts from 0x01 and ends on 0x09
■
(progressively), then performs again,
show all the information including statistics,
■
routes are not recorded,
■
send ECHO-REQUEST according to route selection,
■
default length of ECHO-REQUEST is 56 bytes.,
■
default timeout of ECHO-RESPONSE is 2000ms,
■
do not display other ICMP packets (non ECHO-RESPONSE),
■
the TOS value of echo requests is 0.
■
The command sends ICMP ECHO-REQUEST message to the destination. If
ping
the network to the destination works well, then the destination host will send
ICMP ECHO-REPLY to the source host after receiving ICMP ECHO-REQUEST.
Perform the
quality. The output information includes:
Responses to each of the ECHO-REQUEST messages. If the response message is
■
not received until timeout, output "Request time out". Or display response
message bytes, packet sequence number, TTL and response time.
The final statistics, including number of sent packets, number of response
■
packets received, percentage of non-response packets and
minimal/maximum/average value of response time.
If the network transmission rate is too low to increase the response message
timeout.
For the related commands, see
Example
Check whether the host 202.38.160.244 is reachable.
<SW5500>ping 202.38.160.244
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packets transmitted
5 packets received
0% packet loss
round-trip min/avg/max = 1/2/3 ms

tracert

Syntax
tracert [[ -a
nqueries
-q
command to troubleshoot the network connection and line
ping
tracert
source-ip first-TTL
] -f
timeout
] [ -w ]
Network Connection Test Commands
.
max-TTL
] [ -m
string
451
port
] [ -p ] [