Memory Auto-Establish Disable - 3Com 5500-EI PWR Reference Manual

When you configure the memory command, the safety-value argument in the command must be
greater than the limit-value argument; otherwise, the configuration will fail.
Examples
# Set the lower limit of the switch free memory to 1 MB and the safety value to 3 MB.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] memory safety 3 limit 1

memory auto-establish disable

Syntax
memory auto-establish disable
View
System view
Parameters
None
Description
Use the memory auto-establish disable command to disable the automatic restoration of routing
protocol connection (even if the free memory recovers to a safety value).
By default, when the free memory of the switch recovers to a safety value, connections of all the routing
protocols will always recover (when the free memory of the switch decreases to a lower limit, the
connection will be disconnected forcibly).
After this command is used, connections of all the routing protocols will not recover when the free
memory of the switch recovers to a safety value. In this case, you need to restart the routing protocol to
recover the connections.
Use this command with caution.
Related commands: memory auto-establish enable, memory, display memory limit.
Examples
# Disable automatic restoration of the routing protocol connections when the free memory of the current
switch recovers.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] memory auto-establish disable
6-4