Ntp Configuration Commands; Debugging Ntp-Service - 3Com 5500G-EI Command Reference Manual

NTP Configuration
Commands

debugging ntp-service

This section describes the Network Time Protocol (NTP) configuration commands
available on your Switch 5500G-EI.
Syntax
debugging ntp-service { access | adjustment | authentication | event
| filter | packet | parameter | refclock | selection |
synchronization | validity | all }
undo debugging ntp-service { access | adjustment | authentication |
event | filter | packet | parameter | refclock | selection |
synchronization | validity | all }
View
User view.
Parameter
: NTP access control debugging.
access
: NTP clock adjustment debugging.
adjustment
: All NTP debugging functions.
all
: NTP authentication debugging.
authentication
: NTP event debugging.
event
: NTP filter information debugging.
filter
: NTP packet debugging.
packet
: NTP clock parameter debugging.
parameter
: NTP reference clock debugging.
refclock
: NTP clock selection information debugging.
selection
: NTP clock synchronization information debugging.
synchronization
: NTP remote host validity debugging
validity
Description
Use the
debugging ntp-service
the
undo debugging ntp-service
debugging function.
By default, no debugging function is enabled.
Example
Enable NTP access control debugging.
<SW5500>debugging ntp-service access

NTP Configuration Commands

command to debug different NTP services. Use
command to disable corresponding
501