Display Stp Tc; Reset Stp - 3Com 5500G-EI Command Reference Manual

328 C 10: U
HAPTER SING
stp loop-protection
RSTP C
OMMANDS
Parameter
Sets the current Ethernet port as an edge port.
enable:
Sets the current Ethernet port as a non-edge port.
disable:
Description
Use the
stp edged-port enable
edge port.
Use the
stp edged-port disable
non-edge port.
Use the
undo stp edged-port
By default, all the Ethernet ports of the bridge are configured as non-edge ports.
If the current Ethernet port is connected to other Switch, you can use the
edged-port disable
non-edge port. The stp edged-port enable command can be used to configure the
current Ethernet port as an edge port. All the Ethernet ports have been set to
non-edge ports by default. You can configure the Ethernet ports directly
connected to the user terminals as edge ports, so that they can transition to
forwarding state quickly.
Related command:
Example
To set GigabitEthernet1/0/1 as a non-edge port, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface GigabitEthernet1/0/1
[SW5500-GigabitEthernet1/0/1]stp edged-port disable
Syntax
stp loop-protection
undo stp loop-protection
View
Ethernet Port View
Parameter
none
Description
Use the
stp loop-protection
Use the
undo stp loop-protection
By default, the loop protection function is not enabled.
command to configure the current port as an
command to configure the current port as a
command to restore the default setting.
or
undo stp edged-port
.
stp point-to-point
command to enable loop protection function.
command to restore the setting.
command to specify it as a
stp